lock-nut

单词lock-nut

基本解释

n.: 锁紧螺母
网络: 锁紧螺帽；锁定螺母；防松螺母

英汉解释

• 锁紧螺母

例句

• Disassemble the door-frame, loosen the lock nut, and hammer it out.

  分解门锁，松开锁住部分，然后将折断部分敲出。

• Small bearings with a bore diameter up to 100 mm can be properly mounted by measuring the lock nut tightening angle .

  孔径最大为100毫米的小型轴承可通过测量锁定螺母的紧固角度正确安装。

• Can counterclockwise unscrewing the grip the lock nut and adjust control again, until the nut spin twist clearance fit.

  可以逆时针拧松握把根部的锁紧螺母，再左右旋拧调整螺母，直到间隙合适为止。

• The problems in lock nut of roll axis and sleeve of precision rolling mill are analyzed, some measures proposed, good result got.

  针对高速线材生产中，精轧机辊轴及隔套锁紧螺母存在的问题进行分析，提出了改进措施，取得了较好效果。

• Disc is fastened securely to disc hanger with a lock nut and cotter pin .

  通过一个锁紧螺母和开口销将阀瓣安全紧固在阀瓣支架上。

• After completing adjustments, tighten the lock nut and replace the fast fill lever cap.

  在调节完成后，紧固锁紧螺母，重新安装快速进水手柄帽。

• The two-piece Hard Lock Nut is easy to install, requiring only the use of a wrench.

  双件套强力锁紧螺母安装简便，只需要一个扳手就行。

• lock nut holds the setting at the precise measurement.

  防松螺母使设置保持精密的测量。

• I know what I"m doing. I don"t need any lock nut.

  我知道我在做什么我不需要什么螺母

• V. Notes 1. Replacement blades to compress the lock nut, otherwise, saw people flying out of injury accidents caused by equipment;

  五、注意事项1.更换锯片必须锁压紧螺母，否则，锯片飞出造成设备人伤事故；